Chassis setup · spring · roll · damping

Suspension Optimizer

Defaults are loaded from your 135i. Edit any input and every result recomputes. Geometry values (roll centers, CG, track) are estimates — set them to your measured numbers.

Inputs

Car & corner data

Current setup

Ride frequency & critical damping

Spring solver

Pick ride frequencies → recommended spring rates

Flat ride · Olley pitch–bounce

Flat-ride speed = L·f_f·f_r / (f_r − f_f): the speed at which the rear catches the front's phase so the car heaves instead of pitching. Needs the rear higher than the front. The right column back-solves the rear frequency + spring for a speed you choose (holding the front target). Softer springs lower critical damping, so your effective ζ rises for the same clicks — re-tune dampers after a spring change.

Roll balance

Lateral load transfer distribution

LLTD is the front share of total lateral load transfer: elastic (springs+bars) + geometric (roll centers) + unsprung. Higher front share ⇒ more understeer. The solver holds everything fixed except the chosen bar.

Damping

Damper builder & critical-damping chart

Rebound
Low-speed damping ratio ζ
Knee velocity (in/s)
Slope after knee (% of LS)
Compression
Low-speed damping ratio ζ
Knee velocity (in/s)
Slope after knee (% of LS)
Force vs shaft velocity
Measured damping ratio ζ vs shaft velocity

Rebound and compression are independent — set each one's low-speed ζ, knee, and after-knee slope. Slope >100% is progressive, <100% digressive, and negative is regressive / blow-off (force falls off past the knee, floored at zero). The reb:comp ratio is calculated from the two curves. Low speed (≤2–3 in/s) governs roll/pitch/heave; high speed governs bump compliance.